I find that my 3 tyre jockey wheel tends to dig in to the ground.Can somebody recommend/advise on a single blow up/pneumatic tyre type jockey wheel that I can fit.

Eish, that is bad.

Do you know what the nose weight is?

Sounds like you could be too heavy at the front? Ideally it should not be over 120kg.

Is dit as jy die movers gebruik?

Hi Al.     Johan, bloemfontein hier.

Hier is n draad somewhere van jocky wiele. 

DIETER   gebruik n bree wiel op sy exclusive. Dis soos in n "vet-tekkie-met-wide-rims"

Ek het al my goete verkoop, oppomp wiele inkluis.

Hi Oom Jeep,

Waar vind ek die informasie oor daai oppomp wiel

Click op onderstaande link...hoop daar kan jy miskien paar idees kry.

L I N K

Hi All,

My double door fridge in my Exclusive seems to have become unstable/loose after a long trip,are there any tightening bolts/nuts etc and how does one go about it.

Thanks in advance

had the same problem on my exclusive, the movers are only as good as your jockey wheel, i cut an old piece of conveyer belt into 500x 250   strippes x 6 pieces . and place them under and around the jockey wheel and move them as i move the caravan, works well. i dont have space to store a bigger nose wheel high enough as i have mounted the vacume brake booster assembly in that space , its not the nose wieght, some campsites just have very soft ground

there are two outside vent type doors behind the fridge, one quite high one quite low, the fridges are mostly rivited or screwed to brackets through axcess gained from those two vent doors.

Thanks kindly for help and advice

Alan het jy reggekom om die yskas weer vas te kry?

Hi Leon.

Dankie baie my maat ek het daai skroewe gevind and vas gemaak. Ek moet nou net hulle vyn tyt tot tyd   check nou weet ek waar hulle is.

Weer dankie baie - verskoon my afrikaans maar in Durban praat ons dit nooit lanklaas in matric en weermag gepraat!!!!!!!!!!!!!!!!!!!!!

No problem glad you got sorted.

Nothing wrong with your afrikaans. You are doing well........thanks and good luck.

I have a Jurgens Excellence, and the design of the jockey wheel is poor. the wheel itself sits 'behind'' the shaft, but with very little clearance, so if i use the movers, and the wheel digs in even slightly, the shaft digs in as well. the wheel needs to have much more clearance below the shaft. any ideas? 

ideally it should be below the shaft. 

Ek het my 3 wiel afgehaal en vervang met 'n breër enkel wiel wat bietjie groter is. Op sand / sagte grond gooi en die 2 x conveyor bande uit en ry met die jockey wiel  op die bande sonder sukkel.